Overview

Setting up your RGBIC Gel Protected LED Strip is straightforward: connect the strip to your controller, power everything up, configure WLED, and you're ready to create stunning lighting effects.

Connection Flow

5V Power Supply → RGBIC Controller → LED Strip

What You'll Achieve

Once setup is complete, you'll have:

• 180 individually controllable pixels – creating smooth, flowing colour effects
• Wi‑Fi control – from your smartphone or computer
• Voice control – via Alexa or Google Assistant (with compatible controllers)
• Music sync capabilities – for reactive lighting
• 100+ pre‑set effects – plus unlimited custom possibilities

The process is designed to be beginner-friendly, with most of the complexity handled automatically by modern WLED controllers.

About Your LED Strip

• Ultra‑precise control – Each LED acts as its own pixel for maximum granularity
• Cutting points – Can be cut every 1 LED (~1.7 cm) for custom lengths
• Gel protection – Durable coating provides protection while maintaining flexibility

What You'll Need

Essential Components

• RGBIC Controller – We recommend the Candeo WLED Controller, but other WLED-compatible models work too.
• 5V Power Supply – Minimum 1.5A, 3A recommended (see Power Guide below).
• Wi‑Fi Network – 2.4 GHz required; 5 GHz not supported by most controllers.

Tools & Materials

• Small Phillips screwdriver (not required for Candeo WLED Controller).
• Wire strippers (for custom connections).
• Mounting clips or adhesive backing.
• Smartphone or computer for setup.

Power Supply Guide for this LED strip

Minimum:

For 3 metres: 5V, min. 1.5A (7.5W)

Recommended (Suitable for 90% of use cases):

For 3 metres: 5V, 3A (15W) Plug‑in Adapter

• For plug‑in adapters, cut the strip to ≤ 2 m – 3 A is sufficient
• Supports full brightness for most colours and effects
• Handles warm white and typical RGB combinations
• Provides comfortable usage margin

Full Feature Power Supply Requirements

For 3 metres: 5V, 10A (50W) Dedicated Transformer

• Required for full‑brightness pure white output across the entire 3 m strip
• Maximum performance capability

Setting Up

1. Connect the LED strip to the controller.
   1. The Candeo controller uses clearly labelled, easy‑clip terminals:
      1. Red wire (LED Strip) → +5 V terminal
      2. White wire (LED Strip) → DATA terminal
      3. Green wire (LED Strip) → GND terminal
2. Verify your power supply outputs 5 V and connect it.
3. Set up your WLED controller by following these instructions.
4. In WLED Config → LED Preferences, enter the following:
   1. Maximum PSU Current: match your PSU mA rating (e.g., 3000 for 3 A)
      Warning: Do not enter more than your PSU can handle
   2. Length: Enter 180
   3. Colour Mode: GRB
5. Save
6. Verify all LEDs function properly
7. Test different colours and effects
8. Confirm smooth operation before mounting