[C-ZB-LC20] How do I pair my zigbee LED controller to Home Assistant? (Zigbee2MQTT)

[C-ZB-LC20] How do I pair my zigbee LED controller to Home Assistant? (Zigbee2MQTT)


  1. Identify the capabilities of the LED strip you are using, and decide which mode you want to use on the 5-in-1 controller.
  2. Factory Reset the controller:
    1. Method 1:
      1. Press and hold the reset button for 5 seconds. The LED strip will flash 3 times.
    2. Method 2:
      1. Power on the controller.
      2. Within 2 seconds disconnect the power.
      3. Wait for at least 5 seconds.
      4. Repeat steps i. through iii. 5 times.
      5. The LED strip will flash 3 times.
  3. Put the controller into the correct mode by Short Pressing the Opt button cycles through the modes. Press the Opt button until the LED indicates that you have matched the mode of the controller to your LED strip type.
  4. In zigbee2mqtt, click “Permit Join”
Notes
If you are having any issues with your C-ZB-LC20 in zigbee2mqtt, please try using our custom converter.
Instructions can be found here:
If you change mode on your device after pairing, you need to:
  1. Remove the device from zigbee2mqtt
  2. Power cycle your zigbee2mqtt (since this successfully clears the caching of zigbee2mqtt device drivers)
  3. Choose the correct mode on your device
  4. Re-pair