[C-ZB-LC20] How do I pair my zigbee LED controller to Hubitat Elevation?

[C-ZB-LC20] How do I pair my zigbee LED controller to Hubitat Elevation?


  1. Identify the capabilities of the LED strip you are using, and decide which mode you want to use on the 5-in-1 controller.
  2. If you haven't already, please install the custom driver for your mode. Instructions can be found here: Driver Instructions
  3. Factory Reset the controller:
    1. Method 1:
      1. Press and hold the reset button for 5 seconds. The LED strip will flash 3 times.
    2. Method 2:
      1. Power on the controller.
      2. Within 2 seconds disconnect the power.
      3. Wait for at least 5 seconds.
      4. Repeat steps i. through iii. 5 times.
      5. The LED strip will flash 3 times.
    1. Put the controller into the correct mode by Short Pressing the Opt button cycles through the modes. Press the Opt button until the LED indicates that you have matched the mode of the controller to your LED strip type. 
  4. In the Hubitat interface initiate the pairing process. (Adding to your Zigbee Network)
    1. Go to devices.
    2. Click "Add Device".
    3. ​Under "Add device manually" select Zigbee.
Notes
If your Hubitat hub doesn't find the LED controller, please try powering the controller off and on again, or resetting the controller.