[C205] How do I change the switch type?

[C205] How do I change the switch type?



  1. The C205 module is preconfigured to work with toggle/rocker switches.
  2. If you are using Smartthings, Hubitat, ZHA, or zigbee2mqtt, you will have a device setting to change the switch type to “Momentary”.
    Alert
    You must be using the Candeo drivers to access this setting in Smartthings and Hubitat, and the quirk for Home Assistant ZHA.
    Instructions for installing these can be found here:
  3. After changing the setting you must power cycle the module for the setting to take effect.

    • Related Articles

    • [C203/C204/C-ZB-DM204] How do I change the switch type?

      The modules are preconfigured to work with retractive switches, as this allows you to control on/off, and also dimming. If you are using Smartthings, Hubitat, ZHA, or zigbee2mqtt, you will have a device setting to change the switch type to “Toggle”. ...

    • [C204/C-ZB-DM204] My dimming module doesn't work with retractive switches

      The modules are normally preconfigured to work with retractive switches. It has come to our attention that some of our modules may be set to work with toggle switches instead. If you are using Smartthings, Hubitat, ZHA, or zigbee2mqtt, you will be ...

    • [C-WL-LC60] Retractive Switch Notes

      Requirements Retractive switches should be 2 position/way switches (i.e. bottom or top only, no middle, no 2 way/position and off) Retractive switches should also be press to make, not press to break. Some retractive switches have one terminal for ...

    • [C-ZB-LC20] Retractive Switch Notes

      Requirements Retractive switches should be 2 position/way switches (i.e. bottom or top only, no middle, no 2 way/position and off) Retractive switches should also be press to make, not press to break. Some retractive switches have one terminal for ...

    • [C201/C203/C204/C-ZB-DM204] Retractive Switch Notes

      Requirements Retractive switches should be 2 position/way switches (i.e. bottom or top only, no middle, no 2 way/position and off) Retractive switches should also be press to make, not press to break. Some retractive switches have one terminal for ...