[C201/C203/C204/C-ZB-DM204] Retractive Switch Notes
Requirements
- Retractive switches should be 2 position/way switches (i.e. bottom or top only, no middle, no 2 way/position and off)
- Retractive switches should also be press to make, not press to break.
- Some retractive switches have one terminal for each mode, for example the Scolmore click range seem to use L1 for press to make, and L2 for press to break.
- In this case L2 should be avoided.
Related Articles
[C204/C-ZB-DM204] My dimming module doesn't work with retractive switches
The modules are normally preconfigured to work with retractive switches. It has come to our attention that some of our modules may be set to work with toggle switches instead. If you are using SmartThings, Hubitat, ZHA, or zigbee2mqtt, you will be ...[C302-WF] Retractive Switch Notes
Requirements Retractive switches should be 2 position/way switches (i.e. bottom or top only, no middle, no 2 way/position and off) Retractive switches should also be press to make, not press to break. Some retractive switches have one terminal for ...[C203/C204/C-ZB-DM204] Wiring Instructions
Turn off the power To avoid electrical shock and/or equipment damage, disconnect electrical power at the main fuse or circuit breaker before installation and maintenance. Be aware that even if the circuit breaker is off, some voltage may remain in ...[C203/C204/C-ZB-DM204] How do I change the switch type?
The modules are preconfigured to work with retractive switches, as this allows you to control on/off, and also dimming. If you are using Smartthings, Hubitat, ZHA, or zigbee2mqtt, you will have a device setting to change the switch type to “Toggle”. ...[C-ZB-SM205-2G] Will my Zigbee switch module act as a repeater?
All of our mains powered Zigbee products will act as repeaters within your Zigbee mesh network.