My lights are flickering or won't turn off properly
Diagnosing this issue can be complicated and often dependent on many variables that are unique to the wiring in your house.
However, the most common cause is due to either the total load of the lights being too low, or the wattage of one particular bulb being too low. Please ensure that each lamp is minimum 5W although 10W+ will give better results. Please also ensure that the total load of the circuit is minimum 10W.
If the problem persists, please try increasing the minimum brightness setting of the switch by following the steps here .
If increasing the minimum brightness did not solve the problem, we suggest either increasing the load on the circuit by using higher power lamps, or by fitting an LED bypass over the first lamp in the circuit.
Related Articles
C-RF Family - Getting Started
Getting Started with your Candeo wireless products Download the Instruction Manual here: C-RF Family Instruction Manual Wiring Instructions RF Receiver Wiring Instructions Installation Instructions Switch Installation Instructions Factory Reset the ...[C201] My lights won't turn off properly.
Diagnosing this issue can be complicated and often dependent on many variables that are unique to the wiring in your house. However, the most common cause is due to either the total load of the lights being too low, or the wattage of one particular ...[C-ZB-DM201-2G] My lights won't turn off properly.
Diagnosing this issue can be complicated and often dependent on many variables that are unique to the wiring in your house. However, the most common cause is due to either the total load of the lights being too low, or the wattage of one particular ...[C203/C204/C-ZB-DM204] Wiring Instructions
Turn off the power To avoid electrical shock and/or equipment damage, disconnect electrical power at the main fuse or circuit breaker before installation and maintenance. Be aware that even if the circuit breaker is off, some voltage may remain in ...[C-ZB-LC20] Wiring Instructions
Turn off the power. To avoid electrical shock and/or equipment damage, disconnect electrical power at the main fuse or circuit breaker before installation and maintenance. Be aware that even if the circuit breaker is off, some voltage may remain in ...