[C-ZB-LC20] Wiring Instructions

[C-ZB-LC20] Wiring Instructions



  1. Turn off the power.
    1. To avoid electrical shock and/or equipment damage, disconnect electrical power at the main fuse or circuit breaker before installation and maintenance.
    2. Be aware that even if the circuit breaker is off, some voltage may remain in the wires — before proceeding with the installation, be sure no voltage is present in the wiring.
    3. Take extra precautions to avoid accidentally turning the device on during installation.
Notes;
  1. The C2 module can be physically activated using either a single push/retractive switch, or multiple switches in a multi-way configuration.
    1. Pressing once toggles the lights on/off; and holding the switch activates dimming.
    2. Push/retractive switches should be single direction switches i.e. bottom OR top only. 
  2. The C2 module can also be used without switches (smart only control) by only wiring the LEDs.
Toggle/rocker switches are not supported.

RGBCCT wiring



RGBW wiring



RGB wiring



CCT wiring



Dimmer wiring