[CMM-1] Installing the back plate

[CMM-1] Installing the back plate



  1. The Modmote is fitted with a magnetic back plate than can be fixed to any flat surface using the 3M tape attached. Simply remove the cover of the tape and fix the back plate in your desired location.
  2. The remote can then be placed on the back plate, and removed as you wish.

    • Related Articles

    • [CMM-1 Modmote] Zigbee Scene Remote - Getting Started

      Getting Started with your Candeo CMM-1 Download the Instruction Manual here: Modmote Instruction Manual Installation Instructions The Modmote is fitted with a magnetic back plate than can be fixed to any flat surface using the 3M tape attached. ...

    • [CMM-1] Modmote troubleshooting

      The first step we recommend in any troubleshooting is a factory reset. Normally we would suggest simply removing the modmote from your smart hub, and using the reset button to pair it again. If this does not work there is a reset switch underneath ...

    • [CMM-1] Charging the Modmote

      Use a USB-C charger to charge the remote. The LED at button 3 will glow red to indicate charging. A full charge typically takes 4 hours. When charging is complete the LED at button 3 will glow green.

    • [CMM-1] Switching mode

      To switch the mode of the Modmote from Dimming mode to Scene Switch mode (and vice versa), hold down buttons 3 and 4 for 10 seconds, until button 1 flashes green. Wait for 5 seconds before pressing any button, and the remote will switch modes

    • [CMM-1] Using as a Dimmer Switch

      The Candeo Modmote can also be used as a dimmer switch with zigbee lights. To use as a Dimmer Switch, ensure that you have paired both the remote and the zigbee lights you want to control. Open the Modmote in the Smart Life app and select Remote ...