[CMM-1] Changing the buttons

Candeo offers a range of alternative choices for the buttons on the Modmote, allowing you to change them to suit your requirements.

You can remove the button tiles by lifting gently on the outside lip of tthe button tile, with the base of your palm positioned on the centre of tthe remote to hold it steady.

Replacement button tiles can be attached to the remote by positioning the fixings closest to the edge of the device first, and then snapping the button tile into place towards the centre of the device.

​

Our selection of tiles can be found here.

• Related Articles

• [CMM-1] Charging the Modmote

  Use a USB-C charger to charge the remote. The LED at button 3 will glow red to indicate charging. A full charge typically takes 4 hours. When charging is complete the LED at button 3 will glow green.

• [CMM-1 Modmote] Zigbee Scene Remote - Getting Started

  Getting Started with your Candeo CMM-1 Download the Instruction Manual here: Modmote Instruction Manual Installation Instructions The Modmote is fitted with a magnetic back plate than can be fixed to any flat surface using the 3M tape attached. ...

• [CMM-1] Modmote troubleshooting

  The first step we recommend in any troubleshooting is a factory reset. Normally we would suggest simply removing the modmote from your smart hub, and using the reset button to pair it again. If this does not work there is a reset switch underneath ...

• [CMM-1] Switching mode

  To switch the mode of the Modmote from Dimming mode to Scene Switch mode (and vice versa), hold down buttons 3 and 4 for 10 seconds, until button 1 flashes green. Wait for 5 seconds before pressing any button, and the remote will switch modes

• [CMM-1] Using as a Dimmer Switch

  The Candeo Modmote can also be used as a dimmer switch with zigbee lights. To use as a Dimmer Switch, ensure that you have paired both the remote and the zigbee lights you want to control. Open the Modmote in the Smart Life app and select Remote ...