[C210] I cannot connect to Philips Hue or my other Zigbee hub
Please ensure that you have completed a Factory Reset before attempting to pair.
To complete a Factory Reset, please press the button 3 times in quick succession, holding the 3rd press for 2 seconds.
Related Articles
[C210] How do I pair my zigbee dimming plug to Philips Hue?
Factory reset It is recommended that you factory reset the device before pairing to a Zigbee network. Turn on the plug and lamp. Press the button 3 times quickly (holding for at least 2 seconds on the 3rd press). The light will flash twice. Pairing ...
[C210] How do I pair my zigbee dimming plug to my zigbee hub?
For pairing instructions specific to Home Assistant, Hubitat, Philips Hue or Smartthings please click the relevant link below: Home Assistant pairing instructions Hubitat pairing instructions Philips Hue pairing instructions Smartthings pairing ...
[C-ZB-LC20] How do I pair my zigbee LED controller to Philips Hue?
Factory Reset the controller: Method 1: Press and hold the reset button for 5 seconds. The LED strip will flash 3 times. Method 2: Power on the controller. Within 2 seconds disconnect the power. Wait for at least 5 seconds. Repeat steps i. through ...
[C202/C202N] Troubleshooting pairing
Please do a factory reset and try again. If possible, please move the your Hue Bridge / Zigbee hub as close as possible to the switch during set up, and try again. (You can always move it back to it’s normal location later). Please check that your ...
[C203/C204] How I do pair my dimming module to Philips Hue?
Firstly, we recommend doing a factory reset: Turn on the light, press and hold the reset button for over 5 seconds. Then put the switch in network pairing mode. Double press the reset button to activate zigbee pairing mode. In your Philips Hue app, ...