[CMM-1] How do I pair the Modmote with Home Assistant?

[CMM-1] How do I pair the Modmote with Home Assistant? (ZHA)



  1. Add the remote to your Home Assistant:
    1. Open your Home Assistant dashboard.
    2. Go to the menu and click on settings.
    3. Click "Devices & Services".
    4. Click the blue "ADD INTEGRATION" button.
    5. Click "Add Zigbee device".
    6. Home Assistant will scan for new Zigbee devices.
  2. To put the device in pairing mode, press and hold the reset button for 10 seconds using the pin supplied.
    1. The LED at button 1 will blink green to indicate the remote is in pairing mode.

Notes
Please note:
If you haven't installed our modmote quirks, the modmote will typically pair in dimmer mode. You can check and change the mode with the following instructions:
  1. To confirm the mode, open the logbook feed.

    • Related Articles

    • [CMM-1] How do I install a new Home Assistant blueprint?

      The ZHA blueprint works best when used with our ZHA quirks. Instructions can be found at: https://support.candeo.io/portal/en/kb/articles/cmm-1-how-do-i-install-home-assistant-zha-quirks Click the relevant link beneath of this section. This should ...

    • [CMM-1] How do I install Home Assistant ZHA quirks?

      To do this you must have file editor installed on your Home Assistant instance. Editing your configuration.yaml file. On your Home Assistant instance click file editor. Click the folder button ("Browse Filesystem") Select configuration.yaml, and then ...

    • [CSF1TZ] How do I pair my Smartfoss to Home Assistant ZHA?

      We recommend you install our ZHA Smartfoss quirks first. The instructions can be found here: https://support.candeo.io/portal/en/kb/articles/csf1tz-how-do-i-install-home-assistant-zha-quirks Add your dimmer to your Home Assistant: Open your Home ...

    • [CMM-1] How do I pair the Modmote to my zigbee hub?

      For pairing instructions specific to Home Assistant, Hubitat, Smartthings or Tuya Smart Life please click the relevant link below: Home Assistant pairing instructions Hubitat pairing instructions Smartthings pairing instructions Tuya Smart pairing ...

    • [CSF1TZ] How do I install Home Assistant ZHA quirks?

      To do this you must have file editor installed on your Home Assistant instance. Editing your configuration.yaml file. On your Home Assistant instance click file editor. Click the folder button ("Browse Filesystem") Select configuration.yaml, and then ...