[CMM-1] How do I install a new Home Assistant blueprint?

[CMM-1] How do I install a new Home Assistant blueprint?



Warning
Due to the Zigbee2MQTT 2.0.0 update, the Zigbee2MQTT blueprint has been updated, the old blueprint no longer works. (08/01/2025)
If you haven't already installed our original blueprint, you can go ahead and click the Zigbee2MQTT Import to my home assistant button.
If you have installed our original blueprint, please either remove it, and install the new one, or copy and paste the code from the url directly below into your current blueprint:

Notes
The ZHA blueprint works best when used with our ZHA quirks. Instructions can be found at:
  1. Click the relevant link beneath of this section.
    1. This should open your Home Assistant instance in a new tab.
    2. You may need to click "Save" on the first page, to continue.
  2. Click "Open link".
  3. Login to Home Assistant.
  4. Click "PREVIEW".
  5. Click "IMPORT BLUEPRINT"
ZHA



Zigbee2MQTT


    • Related Articles

    • [CMM-1 Modmote] Zigbee Scene Remote - Getting Started

      Getting Started with your Candeo CMM-1 Download the Instruction Manual here: Modmote Instruction Manual Installation Instructions The Modmote is fitted with a magnetic back plate than can be fixed to any flat surface using the 3M tape attached. ...

    • [C-ZB-SR5BR] How do I install a new Home Assistant blueprint?

      ? Available Blueprints ? Candeo C-ZB-SR5BR – Multi-Light Dimming Control up to 4 lights from one SR5BR: ? Buttons 1–4 choose which light is “active”. ? Centre button toggles the active light on/off. ? Rotary ring dims the active light (clockwise ...

    • How to install drivers, quirks and blueprints

      Home Assistant - ZHA & zigbee2mqtt SmartThings Hubitat Home Assistant - ZHA & zigbee2mqtt Quirks (ZHA only) Editing your configuration.yaml file Open Studio Code Server in your Home Assistant instance. Select configuration.yaml, then click inside the ...

    • [CSF1TZ] How do I install Home Assistant ZHA quirks?

      To do this you must have file editor installed on your Home Assistant instance. Editing your configuration.yaml file. On your Home Assistant instance click file editor. Click the folder button ("Browse Filesystem") Select configuration.yaml, and then ...

    • [CMM-1] Charging the Modmote

      Use a USB-C charger to charge the remote. The LED at button 3 will glow red to indicate charging. A full charge typically takes 4 hours. When charging is complete the LED at button 3 will glow green.