[C202/C202N] My lights won't turn off properly
Diagnosing this issue can be complicated and often dependent on many variables that are unique to the wiring in your house.
However, the most common cause is due to either the total load of the lights being too low, or the wattage of one particular bulb being too low. Please ensure that each lamp is minimum 5W although 10W+ will give better results. Please also ensure that the total load of the circuit is minimum 10W.
If the problem persists, please try increasing the minimum brightness setting of the switch by following the steps here .
If increasing the minimum brightness did not solve the problem, we suggest either increasing the load on the circuit by using higher power lamps, or by fitting an LED bypass over the first lamp in the circuit.
See here for the Candeo LED bypass.
Related Articles
[C201] My lights won't turn off properly.
Diagnosing this issue can be complicated and often dependent on many variables that are unique to the wiring in your house. However, the most common cause is due to either the total load of the lights being too low, or the wattage of one particular ...[C302-WF] My lights won't turn off properly
Diagnosing this issue can be complicated and often dependent on many variables that are unique to the wiring in your house. However, the most common cause is due to either the total load of the lights being too low, or the wattage of one particular ...[C202/C202N] Can I use my rotary dimmer as a remote to control the brightess of another device? Or in decoupled mode?
The simple answer to these questions is no, the dimmer can't be used as a remote, nor can it be decoupled. The rotary dimmer must always have a light circuit connected to it, so there is no way to control another device separately from the light ...[C202/C202N] How do I pair my zigbee rotary switch to Home Assistant? (zigbee2mqtt)
Add our custom zigbee2mqtt converter to your zigbee2mqtt instance: https://github.com/candeosmart/zigbee2mqtt Home Assistant will pick the right version for each C202. Factory Reset the switch: Turn on the light, press the knob 5 times with a long ...[C202/C202N] How do I pair my zigbee rotary switch to Home Assistant? (ZHA)
Factory Reset the switch: Turn on the light, press the knob 5 times with a long press on the fifth time (3 seconds). Once reset successfully, the lamp will blink 5 times. Note: All configuration parameters will be reset after the device is reset or ...