Setting Up
[C-ZB-LC20] How do I pair my zigbee LED controller to Home Assistant? (Zigbee2MQTT)
Identify the capabilities of the LED strip you are using, and decide which mode you want to use on the 5-in-1 controller. Factory Reset the controller: Method 1: Press and hold the reset button for 5 seconds. The LED strip will flash 3 times. Method ...
[C-ZB-LC20] How do I pair my zigbee LED controller to my zigbee hub?
For pairing instructions specific to Home Assistant, Hubitat, Philips Hue or Smartthings please click the relevant link below: Home Assistant pairing instructions Hubitat pairing instructions Philips Hue pairing instructions Smartthings pairing ...
[C-ZB-LC20] Advanced configuration
TouchLink to a Zigbee Remote Initiate pairing mode on the controller with on of the following methods: Quickly press the reset button 3 times. Leave the controller disconnected from the power, then reconnect. A controller connected to a zigbee hub ...
[C-ZB-LC20] Wiring Instructions
Turn off the power. To avoid electrical shock and/or equipment damage, disconnect electrical power at the main fuse or circuit breaker before installation and maintenance. Be aware that even if the circuit breaker is off, some voltage may remain in ...
[C-ZB-LC20] How do I pair my zigbee LED controller to Philips Hue?
Factory Reset the controller: Method 1: Press and hold the reset button for 5 seconds. The LED strip will flash 3 times. Method 2: Power on the controller. Within 2 seconds disconnect the power. Wait for at least 5 seconds. Repeat steps i. through ...
[C-ZB-LC20] How do I pair my zigbee LED controller to Samsung Smartthings?
Identify the capabilities of the LED strip you are using, and decide which mode you want to use on the 5-in-1 controller. If you haven't already, please install our custom driver for your mode. Instructions can be found here: Driver Instructions ...
[C-ZB-LC20] How do I pair my zigbee LED controller to Hubitat Elevation?
Identify the capabilities of the LED strip you are using, and decide which mode you want to use on the 5-in-1 controller. If you haven't already, please install the custom driver for your mode. Instructions can be found here: Driver Instructions ...
[C-ZB-LC20] How do I pair my zigbee LED controller to Home Assistant? (ZHA)
Identify the capabilities of the LED strip you are using, and decide which mode you want to use on the 5-in-1 controller. Factory Reset the controller: Method 1: Press and hold the reset button for 5 seconds. The LED strip will flash 3 times. Method ...