FAQs and Troubleshooting
[C-ZB-LC20] Firmware update instructions for Home Assistant (ZHA and zigbee2mqtt)
After the update, the device should report as C-ZB-LC20v2. zigbee2mqtt The update is available directly within the zigbee2mqtt interface. ZHA 1. Create a new folder inside your Home Assistant “config” directory for storing the OTA firmware file. In ...
(LED strips/ropes) Tips & Troubleshooting
General Tips and troubleshooting Test connections before permanent installation When in doubt, consult an electrician for permanent installations Safety First Before You Start Always disconnect power before making any connections or adjustments ...
[C-WL-LC60] Retractive Switch Notes
Requirements Retractive switches should be 2 position/way switches (i.e. bottom or top only, no middle, no 2 way/position and off) Retractive switches should also be press to make, not press to break. Some retractive switches have one terminal for ...
[C-ZB-LC20] Retractive Switch Notes
Requirements Retractive switches should be 2 position/way switches (i.e. bottom or top only, no middle, no 2 way/position and off) Retractive switches should also be press to make, not press to break. Some retractive switches have one terminal for ...
[C-ZB-LC20] Zigbee2mqtt converter
We do have a converter available for zigbee2mqtt. This is built in to the most up to date zigbee2mqtt, however if you require it please find it here: Zigbee2mqtt Converter
[C-WL-LC60] My WLED controller is restarting
If you find that your WLED LED strip controller is restarting, please try the following steps: Open your WLED web app, and go to Config Select Wifi Setup Locate the section "mDNS address (leave empty for no mDNS):", and delete the entry inbetween ...
[C-WL-LC60] Advanced configuration
LED strip configuration Go to the WLED control page and click on the "Config" button. in the upper right corner. Then, select "LED Preferences" and navigate to "Hardware setup" to configure the LED strip information. Relay configuration Go to the ...
[C-ZB-LC20] Advanced configuration
TouchLink to a Zigbee Remote Initiate pairing mode on the controller with on of the following methods: Quickly press the reset button 3 times. Leave the controller disconnected from the power, then reconnect. A controller connected to a zigbee hub ...