[C-ZB-SM205-2G] How do I pair my zigbee lighting module to Hubitat Elevation?
Please note you only need to import the drivers once. After the import all new C-ZB-SM205-2G devices will pick up the new driver.
- Add the module to your Zigbee hub or bridge:
- Initiaite pairing mode to pair to Hubitat. (Adding to your Zigbee Network)
- Open your Hubitat dashboard.
- Go to devices.
- Click "Add Device".
- Under "Add device manually" select zigbee.
- The lamp will blink 5 times and then stay on to indicate successful pairing.
- If the hub does not successfully pair with the module, power the module off and power on, and try again within 15 seconds of powering on.
Related Articles
[C-ZB-LC20] How do I pair my zigbee LED controller to Hubitat Elevation?
Factory Reset the controller: Method 1: Press and hold the reset button for 5 seconds. The LED strip will flash 3 times. Method 2: Power on the controller. Within 2 seconds disconnect the power. Wait for at least 5 seconds. Repeat steps i. through ...
[C-ZB-SM205-2G] How do I pair my zigbee lighting module to my zigbee hub?
For pairing instructions specific to Home Assistant, Hubitat or Smartthings please click the relevant link below: Home Assistant (ZHA) pairing instructions Home Assistant (Zigbee2MQTT) pairing instructions Hubitat pairing instructions Philips Hue ...
[C-ZB-SM205-2G] How do I pair my zigbee lighting module to Home Assistant? (zigbee2mqtt)
Add our custom zigbee2mqtt converter to your zigbee2mqtt instance: https://github.com/candeosmart/zigbee2mqtt Factory Reset the module: After powering on the module for the first time, the lamp should slowly blink. If it does not blink, you will need ...
[C-ZB-SM205-2G] How do I pair my zigbee lighting module to Samsung Smartthings?
Factory Reset the module: After powering on the module for the first time, the lamp should blink. If it does not blink, you will need to factory reset the device. To do this, press the reset button 5 times. If the module is not accessible, switch the ...
[C205] How do I pair my zigbee lighting module to Hubitat Elevation?
Factory Reset the module: After powering on the module for the first time, the lamp should blink. If it does not blink, you will need to factory reset the device. To do this, press the reset button 5 times. If the module is not accessible, switch the ...