[C-ZB-SM205-2G] Advanced configuration

[C-ZB-SM205-2G] Advanced configuration













Set up a Touchlink remote
  1. Press the reset button 4 times or turn the power off/on 4 times.
  2. Bring the remote within 10cm of the module and set the remote into Touchlink commissioning mode. You will need to refer to the instructions that came with the remote to do this.
  3. Once connected, the light will flash twice, and you can control your lights remotely.
Please Note:
  1. When both devices (dimmer module and remote) are not included in a Zigbee network, each module can connect with up to 1 remote control.
  2. When both devices are included in the same Zigbee network, each dimmer can connect with up to 30 remote controls.
  3. To control within your smart ecosystem and Touchlink remote, first add the remote and the device to network, and then begin Touchlink pairing.

Find and Bind

  1. Make sure that both the module and the remote are already paired to the same zigbee network.
  2. Press the reset button 3 times or turn the power off/on 3 times.
  3. Bring the remote or touch panel within 10cm of the module.
  4. Set the remote or touch panel into Find and Bind mode. You will need to refer to the instructions that came with the remote to do this.
  5. There will be an indication on the remote that Find and Bind mode has been successfully established.

    • Related Articles

    • [C203/C204] Advanced configuration

      Set up a Touchlink remote Press the reset button 4 times or turn the power off/on 4 times. Bring the remote within 10cm of the module and set the remote into Touchlink commissioning mode. You will need to refer to the instructions that came with the ...
    • [C205] Advanced configuration

      Set up a Touchlink remote Press the reset button 4 times or turn the power off/on 4 times. Bring the remote within 10cm of the module and set the remote into Touchlink commissioning mode. Refer to the remote's instructions for this step. Once ...
    • [C201] Advanced configuration

      TouchLink to a Zigbee Remote Press the reset button 4 times. The LED will start blinking green indicating that the module is ready for Touchlink mode. Pairing mode will time out after 15 minutes. Bring the remote within 10cm of the module and set the ...
    • [C-ZB-LC20] Advanced configuration

      TouchLink to a Zigbee Remote Initiate pairing mode on the controller with on of the following methods: Quickly press the reset button 3 times. Leave the controller disconnected from the power, then reconnect. A controller connected to a zigbee hub ...
    • [C-ZB-SM205-2G] Instruction booklet

      Instruction booklet for C-ZB-SM205-2G can be downloaded here.