[C-ZB-LC20] How do I pair my zigbee LED controller to Samsung Smartthings?

1. Factory Reset the controller:
   
1. Method 1:
   
1. Press and hold the reset button for 5 seconds. The LED strip will flash 3 times.
   
2. Method 2:
   
1. Power on the controller.
   
2. Within 2 seconds disconnect the power.
   
3. Wait for at least 5 seconds.
   
4. Repeat steps i. through iii. 5 times.
   
5. The LED strip will flash 3 times.
   
2. Add the module to your Zigbee hub or bridge:
   
1. Open your Smartthings app.
   
1. Go to devices.
   
2. Select the room of your choice.
   
3. Tap the +.
   
4. Choose "Add a device".
   
5. Choose  "Scan nearby".
   
3. Put the lighting module into pairing mode:
1. Connect the controller the power source.
   

If your Smartthings hub doesn't find the LED controller, please try powering the controller off and on again, or resetting the controller.

• Related Articles

• [C-ZB-LC20] How do I pair my zigbee LED controller to my zigbee hub?

  For pairing instructions specific to Home Assistant, Hubitat, Philips Hue or Smartthings please click the relevant link below: Home Assistant pairing instructions Hubitat pairing instructions Philips Hue pairing instructions Smartthings pairing ...

• [C-ZB-LC20] How do I pair my zigbee LED controller to Hubitat Elevation?

  Factory Reset the controller: Method 1: Press and hold the reset button for 5 seconds. The LED strip will flash 3 times. Method 2: Power on the controller. Within 2 seconds disconnect the power. Wait for at least 5 seconds. Repeat steps i. through ...

• [C-ZB-LC20] How do I pair my zigbee LED controller to Philips Hue?

  Factory Reset the controller: Method 1: Press and hold the reset button for 5 seconds. The LED strip will flash 3 times. Method 2: Power on the controller. Within 2 seconds disconnect the power. Wait for at least 5 seconds. Repeat steps i. through ...

• [C-ZB-LC20] How do I pair my zigbee LED controller to Home Assistant?

  Factory Reset the controller: Method 1: Press and hold the reset button for 5 seconds. The LED strip will flash 3 times. Method 2: Power on the controller. Within 2 seconds disconnect the power. Wait for at least 5 seconds. Repeat steps i. through ...

• [C-ZB-SM205-2G] How do I pair my zigbee lighting module to Samsung Smartthings?

  Factory Reset the module: After powering on the module for the first time, the lamp should blink. If it does not blink, you will need to factory reset the device. To do this, press the reset button 5 times. If the module is not accessible, switch the ...