[C-RF-SSGR1-1CH/C-RF-SSGR1-2CH] Can I use my kinetic grid switches with other grid systems?

At present, our kinetic grid switches are only confirmed to be compatible with the MK Grid Plus system.

Important Note: The MK Grid Plus system uses a two-layer design, requiring both a faceplate and a fixing plate (yoke). These components are available in various sizes to match the number of gangs on your faceplate.

• Related Articles

• [C-RF-SSGR1/C-RF-SSP1/C-ACGRFP] How do I install my kinetic switch?

  C-RF-SSGR1 Grid Switches with C-ACGRFP Faceplates To install our SSGR1 grid switches in the C-ACGRFP faceplates, locate the slot in the edge of the faceplate and carefully use a screwdriver to pop open the faceplate. The switches then clip securely ...

• [C-RF Family] Getting Started

  Getting Started with your Candeo wireless products Download the Instruction Manual here: C-RF Family Instruction Manual Wiring Instructions RF Receiver Wiring Instructions Installation Instructions Switch Installation Instructions Factory Reset the ...

• [C-WL-LC60] Retractive Switch Notes

  Requirements Retractive switches should be 2 position/way switches (i.e. bottom or top only, no middle, no 2 way/position and off) Retractive switches should also be press to make, not press to break. Some retractive switches have one terminal for ...

• [C202] Can I remove the faceplate?

  Yes you can. The rotary knob can be pulled off giving the access to remove the faceplate. Alternatively – you might be interested in the C202N which is sold without a faceplate. Buy C202N here.

• [All Kinetic Receivers] Wiring Instructions

  Please note that while a wired switch can remain in place, it should no longer be used to control the light, as doing so would switch off the receiver. The most common place to install our receivers is just before the light fixture, as the light ...