[CMM-1] Using as a Dimmer Switch

[CMM-1] Using as a Dimmer Switch



The Candeo Modmote can also be used as a dimmer switch with zigbee lights.

  1. To use as a Dimmer Switch, ensure that you have paired both the remote and the zigbee lights you want to control.
  2. Open the Modmote in the Smart Life app and select Remote Dimming from the function menu.
  3. Hold down button 1 for 10 seconds until the icon starts flashing green.
  4. Choose Add Smart Lights and “Go to add.”
  5. Select the lights you want to add, and select Save.
  6. The buttons will now be assigned as follows:
    1. Button 1 = on
    2. Button 2 = off
    3. Button 3 = increase brightness
    4. Button 4 = decrease brightness

    • Related Articles

    • [CMM-1] How do I pair the Modmote with Hubitat Elevation?

      Install the custom driver On your Hubitat instance, go to Drivers code. Click "+ New driver". Click "Import". Paste the following web address into the box that pops up: ...

    • [CMM-1] Using as a Scene Switch (Primary function)

      To use as a Scene Switch, select the remote within the Smart Life app, and select Device Trigger from within the function menu (bottom right button). From here you can create multi-device actions for each button using the “Create Intelligence” ...

    • [CMM-1] Charging the Modmote

      Use a USB-C charger to charge the remote. The LED at button 3 will glow red to indicate charging. A full charge typically takes 4 hours. When charging is complete the LED at button 3 will glow green.

    • [CMM-1] Modmote troubleshooting

      The first step we recommend in any troubleshooting is a factory reset. Normally we would suggest simply removing the modmote from your smart hub, and using the reset button to pair it again. If this does not work there is a reset switch underneath ...

    • [CMM-1] Instruction booklet

      Instruction booklet for CMM-1 can be downloaded here.