[C302-WF] My lights won't turn off properly
Diagnosing this issue can be complicated and often dependent on many variables that are unique to the wiring in your house.
However, the most common cause is due to either the total load of the lights being too low, or the wattage of one particular bulb being too low. Please ensure that each lamp is minimum 5W although 10W+ will give better results. Please also ensure that the total load is minimum 10W.
If the problem persists, please try increasing the minimum brightness setting of the switch by following the steps on page 3 in the instruction manual.
If increasing the minimum brightness did not solve the problem, we suggest either increasing the load on the circuit by using higher power lamps, or by fitting an LED bypass over the first lamp in the circuit.
See here for the Candeo LED bypass.
Related Articles
[C-WF-SSFS] Smart Switch Fused Spur - Getting Started
Getting Started with your Candeo C-WF-SSFS Download the Instruction Manual here: C-WF-SSFS Instruction Manual Wiring Instructions Turn off the power. Connect the power supply (Live and Neutral) to terminals marked L IN (brown/red cable) and N IN ...[C302-WF] My lights are flickering at low levels
Diagnosing this issue can be complicated and often dependent on many variables that are unique to the wiring in your house. However, the most common cause is due to either the total load of the lights being too low, or the wattage of one particular ...[C201] My lights won't turn off properly.
Diagnosing this issue can be complicated and often dependent on many variables that are unique to the wiring in your house. However, the most common cause is due to either the total load of the lights being too low, or the wattage of one particular ...[C302-WF] - Getting Started
Getting Started with your Candeo C302-WF Download the Instruction Manual here: C302-WF Instruction Manual Wiring Instructions C302-WF Wiring Instructions Installation Instructions Please follow the wiring instructions article linked above, and then ...[C302-WF] Retractive Switch Notes
Requirements Retractive switches should be 2 position/way switches (i.e. bottom or top only, no middle, no 2 way/position and off) Retractive switches should also be press to make, not press to break. Some retractive switches have one terminal for ...