[C302-WF] Changing the dimming mode

[C302-WF] Changing the dimming mode



It is possible to change the dimming mode from Trailing Edge to Leading Edge (and vice versa). The default
dimming mode is Trailing Edge and is suitable for most modern lighting applications. Should you need to
change the dimming mode, please follow these steps:

  1. To switch to Leading Edge:
    1. Turn the light on and press the knob 5 times, with a long press on the 5th time.
    2. The light will blink 5 times to indicate Leading Edge mode.
  2. To switch to Trailing Edge:
    1. Turn the light on and press the knob 4 times, with a long press on the 4th time.
    2. ​The light will blink 3 times to indicate Trailing Edge mode.

    • Related Articles

    • [C302-WF] Instruction booklet

      The instruction booklet for C302-WF can be downloaded here.
    • [C302-WF] Retractive Switch Notes

      Requirements Retractive switches should be 2 position/way switches (i.e. bottom or top only, no middle, no 2 way/position and off) Retractive switches should also be press to make, not press to break. Some retractive switches have one terminal for ...
    • [C302-WF] Pairing to Smart Life

      Factory reset the switch: Press and hold the knob for 10 seconds. The light will blink twice to confirm a successful reset. Make sure your phone is prepared: Install the Smart Life app from your store (you can scan the qr code or click the links): ...
    • [C302-WF] Wiring Instructions

      Turn off the power To avoid electrical shock and/or equipment damage, disconnect ectrical power at the main fuse or circuit breaker before installation and maintenance. Be aware that even if the circuit breaker is off, some voltage may remain in the ...
    • [C202/C202N] Can I use my rotary dimmer as a remote to control the brightess of another device? Or in decoupled mode?

      The simple answer to these questions is no, the dimmer can't be used as a remote, nor can it be decoupled. The rotary dimmer must always have a light circuit connected to it, so there is no way to control another device separately from the light ...