[C205] Troubleshooting

Please ensure that you have followed all of the instructions precisely.

The module will not pair with the hub

1. Please ensure that your hub is in range, typically <30m indoors.
   
2. Please do a factory reset as outlined above, and try pairing again.
   
3. Please ensure that you have not exceeded the maximum amount of devices allowed for your hub.
   

The lights are glowing when they are turned off (C205)

1. Please try increasing the load by using higher power LEDs.
   
2. Or alternatively, please install a LED bypass on the circuit.

To remove the module from the Zigbee network

1. Remove the device from your Zigbee network by following the instructions in your smart app.
   
2. Press the reset button 5 times.
   
3. The connected lights will blink 3 times.

• Related Articles

• [C-ZB-SM205-2G] Troubleshooting

  Please ensure that you have followed all of the instructions precisely. The module will not pair with the hub Please ensure that your hub is in range, typically <30m indoors. Please do a factory reset as outlined above, and try pairing again. Please ...

• [C203/C204/C-ZB-DM204] Troubleshooting

  Please ensure that you have followed all of the instructions precisely. The module will not pair with the hub Please ensure that your hub is in range, typically <30m indoors. Please do a factory reset as outlined above, and try pairing again. Please ...

• [C203/C204/C-ZB-DM204] Instruction booklet

  Instruction booklet for C203 and C204/C-ZB-DM204 can be downloaded here.

• [C-ZB-DM201-2G] Instruction booklet

  Instruction booklet for C-ZB-DM201-2G can-be downloaded here.

• [C202/C202N] Troubleshooting pairing

  Please do a factory reset and try again. If possible, please move the your Hue Bridge / Zigbee hub as close as possible to the switch during set up, and try again. (You can always move it back to it’s normal location later). Please check that your ...