[C205] How do I pair my zigbee lighting module to Hubitat Elevation?

1. Factory Reset the module:
1. After powering on the module for the first time, the lamp should blink. If it does not blink, you will need to factory reset the device.
2. To do this, press the reset button 5 times.
3. If the module is not accessible, switch the power off and on 5 times.
4. The lamp will blink 3 times to indicate a successful factory reset.
2. Import the custom driver:
1. On your Hubitat instance, go to Drivers code.
2. Click "+ New driver".
3. Click "Import".
4. Paste the following into the box that pops up:
1. C205 Zigbee Switch Module
5. Click "Import".
6. Click "Save".
Please note you only need to import the driver once. After the import, all new C205 devices will pick up the new driver. We recommend that any C205 devices added previously be unpaired and then paired again after a factory reset.
3. Add the module to your Zigbee hub or bridge:
1. Initiate pairing mode to pair to Hubitat. (Adding to your Zigbee Network)
1. Open your Hubitat dashboard.
2. Go to devices.
3. Click "Add Device".
4. Under "Add device manually," select Zigbee.
4. The lamp will blink 5 times and then stay on to indicate successful pairing.
1. If the hub does not successfully pair with the module, power the module off and on, then try again within 15 seconds of powering on.

• Related Articles

• [C-ZB-SM205-2G] How do I pair my zigbee lighting module to Hubitat Elevation?

  Factory Reset the module: After powering on the module for the first time, the lamp should blink. If it does not blink, you will need to factory reset the device. To do this, press the reset button 5 times. If the module is not accessible, switch the ...

• [C201] How do I pair my zigbee lighting module to Hubitat Elevation?

  Please note the new driver is currently for product codes #10 and above. Do not install it if your product code # is below 10. You can identify the # code on the back of the device. If you have multiple devices, of both compatible and incompatible ...

• [C-RFZB-SM1] How do I pair my zigbee kinetic module to Hubitat Elevation?

  To initiate pairing mode to pair to Hubitat, open your Hubitat dashboard: Go to Devices. Click "Add Device". Under "Add device manually" select zigbee. Press and hold the Control Button on the receiver for 10-15 seconds to simultaneously factory ...

• [C-ZB-LC20] How do I pair my zigbee LED controller to Hubitat Elevation?

  Factory Reset the controller: Method 1: Press and hold the reset button for 5 seconds. The LED strip will flash 3 times. Method 2: Power on the controller. Within 2 seconds disconnect the power. Wait for at least 5 seconds. Repeat steps i. through ...

• [C203/C204] How do I pair my zigbee lighting module to Hubitat Elevation?

  Factory reset the module: After powering on the module for the first time, the lamp should slowly blink. If it does not blink, you will need to factory reset the device. To do this, press the reset button 5 times. If the module is not accessible, ...