[C203/C204] Troubleshooting

[C203/C204] Troubleshooting










Please ensure that you have followed all of the instructions precisely.

The module will not pair with the hub
  1. Please ensure that your hub is in range, typically <30m indoors.
  2. Please do a factory reset as outlined above, and try pairing again.
  3. Please ensure that you have not exceeded the maximum amount of devices allowed for your hub.
The lights are flickering at low levels or glowing when they are turned off (C204)
  1. Please try increasing the load by using higher power LEDs.
  2. Or alternatively, please install a LED bypass on the circuit.
To remove the module from the zigbee network
  1. Remove the device from your Zigbee network by following the instructions in your smart app.
  2. Press the reset button 5 times.
  3. The connected lights will blink 3 times.

    • Related Articles

    • [C-ZB-SM205-2G] Troubleshooting

      Please ensure that you have followed all of the instructions precisely. The module will not pair with the hub Please ensure that your hub is in range, typically <30m indoors. Please do a factory reset as outlined above, and try pairing again. Please ...

    • [C205] Troubleshooting

      Please ensure that you have followed all of the instructions precisely. The module will not pair with the hub Please ensure that your hub is in range, typically <30m indoors. Please do a factory reset as outlined above, and try pairing again. Please ...

    • [C-ZB-SM205-2G] How do I pair my zigbee lighting module to Home Assistant? (zigbee2mqtt)

      Add our custom zigbee2mqtt converter to your zigbee2mqtt instance: https://github.com/candeosmart/zigbee2mqtt Factory Reset the module: After powering on the module for the first time, the lamp should slowly blink. If it does not blink, you will need ...

    • [C-ZB-SM205-2G] How do I pair my zigbee lighting module to Hubitat Elevation?

      Factory Reset the module: After powering on the module for the first time, the lamp should blink. If it does not blink, you will need to factory reset the device. To do this, press the reset button 5 times. If the module is not accessible, switch the ...

    • [C-ZB-SM205-2G] Will my zigbee switch module act as a repeater?

      All of our mains powered zigbee products will act as repeaters within your zigbee mesh network.