[C203/C204] Setting minimum brightness

[C203/C204] Setting minimum brightness












  1. Adjust the brightness to the desired minimum level using your smart controller app  This is typically the lowest level possible where a dim glow is visible without any flickering. 
  2. Press and hold the Min Set button on the module for 3 seconds (C204) or until the light flashes (C203).
The minimum brightness should be between 1% and 50% for the C204.

Reset the minimum brightness
  1. Adjust the brightness to 100% using your smart controller app.
  2. Press and hold the Min Set button on the module for 3 seconds (C204) or until the light flashes (C203).
  3. The minimum brightness setting has now been removed.

    • Related Articles

    • [C202/C202N] Setting the minimum brightness

      Turn on the light, then press the knob 3 times. The light will blink twice showing that the device is in configuration mode. Adjust the minimum brightness to the lowest level you are satisfied with, then press the knob once to save it.

    • [C201] Adjusting dimming settings

      To optimise the performance of the smart module, or to adjust the settings to your preference, you can adjust the brightness at the Min. and Max. level, and adjust dimming speed. MIN adjustment - Switch on the lights. When the lights are on, insert a ...

    • [C302-WF] Setting the minimum brightness

      Open the Smart Life app and select the device. Turn on the light, and select the settings icon. Ensure that the brightness range settings are unlocked by touching the padlock icon. You can now configure the minimum brightness level for the switch. ...

    • [C210] How do I pair my zigbee dimming plug to Home Assistant?

      Factory reset It is recommended that you factory reset the device before pairing to a Zigbee network. Turn on the plug and lamp. Press the button 3 times quickly (holding for at least 2 seconds on the 3rd press). The light will flash twice. Pairing ...

    • [C210] How do I pair my zigbee dimming plug to Philips Hue?

      Factory reset It is recommended that you factory reset the device before pairing to a Zigbee network. Turn on the plug and lamp. Press the button 3 times quickly (holding for at least 2 seconds on the 3rd press). The light will flash twice. Pairing ...