[C203/C204] How do I pair my zigbee lighting module to Hubitat Elevation?

[C203/C204] How do I pair my zigbee lighting module to Hubitat Elevation?





  1. Factory reset the module:
    1. After powering on the module for the first time, the lamp should slowly blink. If it does not blink, you will need to factory reset the device.
    2. To do this, press the reset button 5 times.
    3. If the module is not accessible, switch the power off and on 5 times.
    4. The lamp will blink 3 times to indicate a successful factory reset.
  2. Import the custom driver:
    1. On your Hubitat instance, go to Drivers code.
    2. Click "+ New driver".
    3. Click "Import".
    4. Paste the following into the box that pops up:
      1. For C203: C203 Zigbee Dimmer Module
      2. For C204: C204 Zigbee Dimmer Module
    5. Click "Import".
    6. Click "Save".
  3. Add the module to your Zigbee hub or bridge:
    1. Initiate pairing mode to pair to Hubitat. (Adding to your Zigbee Network)
      1. Open your Hubitat dashboard.
      2. Go to devices.
      3. Click "Add Device".
      4. Under "Add device manually," select Zigbee.
  4. The lamp will blink 5 times and then stay on to indicate successful pairing.
    1. If the hub does not successfully pair with the module, power the module off and on, then try again within 15 seconds of powering on.
Notes Please note: you only need to import the driver once for each model. After the import, all new devices of that model will pick up the new driver. We recommend any C203/C204 devices previously added are unpaired and then paired again after a factory reset.