[C202/C202N] How do I pair my zigbee rotary switch to Hubitat Elevation?

[C202/C202N] How do I pair my zigbee rotary switch to Hubitat Elevation?


​
Please note the new driver is currently for product codes #10 and above. Do not install it if your product code # is below 10.
You can identify the # code on the back of the device.
If you have multiple devices, of both compatible and incompatible product codes, you can either install the driver and change the drivers individually, or not install the driver.
  1. Factory Reset the switch:
    1. Turn on the light, press the knob 5 times with a long press on the fifth time (3 seconds).
    2. Once reset successfully, the lamp will blink 5 times.
    3. Note: All configuration parameters will be reset after the device is reset or removed from the network.
  2. Import the custom driver:
    1. On your Hubitat instance go to Drivers code.
    2. Click "+ New driver".
    3. Click "Import".
    4. Paste the following into the box that pops up:
      https://raw.githubusercontent.com/candeosmart/hubitat-zigbee/main/Candeo%20C202%20%26%20C202N%20Zigbee%20Rotary%20Dimmer.groovy
    5. Click "Import".
    6. Click "Save".
      7. Please note you only need to import the driver once. After the import all new C202/C202N devices will pick up the new driver. We recommend any C202/C202N devices added previously are unpaired, and then paired again after a factory reset.
  3. To initiate pairing mode to pair to Hubitat, open your Hubitat dashboard:
    1. Go to Devices.
    2. Click "Add Device".
    3. Under "Add device manually" select zigbee.
  4. Turn on your lamp, then double press the knob, with a long press (3 seconds) on the second time.
    1. The light will blink twice to indicate it is in network pairing mode, which will last for 15 minutes. If your connection attempt times out, repeat this step if necessary.
    2. When successfully paired the light will blink once, and then stay continuously on. The device can now be controlled through your controller or hub interface.
      1. If you struggle to pair your device, please try to move either the device or the hub, so they are closer together. You can move them back again after pairing.
  5. Name your device, choose a room, and click next.