[C201] advanced configuration

[C201] Advanced configuration

​
​
TouchLink to a Zigbee Remote
  1. Press the reset button 4 times.
  2. The LED will start blinking green indicating that the module is ready for Touchlink mode. Pairing mode will time out after 15 minutes.
  3. Bring the remote within 10cm of the module and set the remote into Touchlink commissioning mode. Refer to the instructions that came with the remote to do this.
  4. The light will blink 10 times when Touchlink pairing has been successful, and the LED will stay solid green for 10 seconds once pairing is complete.
  5. Once connected, the light will blink 10 times, and you can control your lights remotely.
Notes
Please Note:
  1. When both devices (Dimmer and remote) are not included in a Zigbee network, each module can connect with up to 1 remote control.
  2. When both devices are included in the same Zigbee network, each dimmer can connect with up to 30 remote controls.
  3. For Philips Hue Hubs and Amazon Echo Plus, first add the remote and the device to the network, and then begin Touchlink pairing.

Find and Bind

  1. Press the reset button 5 times.
  2. The LED will start blinking yellow indicating that the module is ready for Find and Bind mode. Pairing mode will time out after 15 minutes.
  3. Set the remote into Find and Bind mode. Refer to the instructions that came with the remote to do this.
  4. There will be an indication on the remote that Find and Bind mode has been successfully established.

    • Related Articles

    • [C203/C204/C-ZB-DM204] Advanced configuration

      Set up a Touchlink remote Press the reset button 4 times or turn the power off/on 4 times. Bring the remote within 10cm of the module and set the remote into Touchlink commissioning mode. You will need to refer to the instructions that came with the ...

    • [C-ZB-SM205-2G] Advanced configuration

      Set up a Touchlink remote Press the reset button 4 times or turn the power off/on 4 times. Bring the remote within 10cm of the module and set the remote into Touchlink commissioning mode. You will need to refer to the instructions that came with the ...

    • [C205] Advanced configuration

      Set up a Touchlink remote Press the reset button 4 times or turn the power off/on 4 times. Bring the remote within 10cm of the module and set the remote into Touchlink commissioning mode. Refer to the remote's instructions for this step. Once ...

    • [C-ZB-DM201-2G] Advanced configuration

      TouchLink to a Zigbee Remote (Channel 1 only) Factory reset the dimming module: Press and hold the “Reset” button for 10 seconds. Turn on the light and press the reset button 4 times. The LED will start blinking green indicating that the module is ...

    • [C-ZB-LC20] Advanced configuration

      TouchLink to a Zigbee Remote Initiate pairing mode on the controller with on of the following methods: Quickly press the reset button 3 times. Leave the controller disconnected from the power, then reconnect. A controller connected to a zigbee hub ...