[C-WL-LC60] My WLED controller is restarting
If you find that your WLED LED strip controller is restarting, please try the following steps:
- Open your WLED web app, and go to Config
- Select Wifi Setup
- Locate the section "mDNS address (leave empty for no mDNS):", and delete the entry inbetween "http://" and ".local".
4. Save and Connect
Related Articles
[C-WL-LC60] WLED Controller - Getting Started
Getting Started with your Candeo C-WL-LC60 Download the Instruction Manual here: C-WL-LC60 Instruction Manual Wiring Instructions Please see our wiring article: [C-WL-LC60] Wiring Instructions Installation Instructions We recommend installing the LED ...[C-WL-LC60] Retractive Switch Notes
Requirements Retractive switches should be 2 position/way switches (i.e. bottom or top only, no middle, no 2 way/position and off) Retractive switches should also be press to make, not press to break. Some retractive switches have one terminal for ...[C-WL-LC60] Wiring Instructions
Turn off the power. To avoid electrical shock and/or equipment damage, disconnect electrical power at the main fuse or circuit breaker before installation and maintenance. Be aware that even if the circuit breaker is off, some voltage may remain in ...[C-WL-LC60] Advanced configuration
LED strip configuration Go to the WLED control page and click on the "Config" button. in the upper right corner. Then, select "LED Preferences" and navigate to "Hardware setup" to configure the LED strip information. Relay configuration Go to the ...[C-ZB-LC20] Wiring Instructions
Turn off the power. To avoid electrical shock and/or equipment damage, disconnect electrical power at the main fuse or circuit breaker before installation and maintenance. Be aware that even if the circuit breaker is off, some voltage may remain in ...