[C-ZB-LC20] Wiring Instructions
- Turn off the power.
- To avoid electrical shock and/or equipment damage, disconnect electrical power at the main fuse or circuit breaker before installation and maintenance.
- Be aware that even if the circuit breaker is off, some voltage may remain in the wires — before proceeding with the installation, be sure no voltage is present in the wiring.
- Take extra precautions to avoid accidentally turning the device on during installation.
Notes;
- The C-ZB-LC20 module can be physically activated using either a single push/retractive switch, or multiple switches in a multi-way configuration.
- Pressing once toggles the lights on/off; and holding the switch activates dimming.
- Push/retractive switches should be single direction switches i.e. bottom OR top only.
- Push/retractive switches should be press to make.
- The C-ZB-LC20 module can also be used without switches (smart only control) by only wiring the LEDs.
Toggle/rocker switches are not supported.
RGBCCT wiring
RGBW wiring
RGB wiring
CCT wiring
Dimmer wiring
Optional switch wiring
Related Articles
[C203/C204/C-ZB-DM204] Wiring Instructions
Turn off the power To avoid electrical shock and/or equipment damage, disconnect electrical power at the main fuse or circuit breaker before installation and maintenance. Be aware that even if the circuit breaker is off, some voltage may remain in ...[C-ZB-LC20] Getting Started
Manual & Documentation Download the Instruction Manual here: C-ZB-LC20 Instruction Manual Wiring Guide Please see our wiring article: [C-ZB-LC20] Wiring Instructions Installation Instructions We recommend installing the LED controller using the ...[C-WL-LC60] WLED Controller - Getting Started
Manual & Documentation Download the Instruction Manual here: C-WL-LC60 Instruction Manual Wiring Guide Please see our wiring article: [C-WL-LC60] Wiring Instructions Installation Instructions We recommend installing the LED controller using the ...[C-WL-LC60] Wiring Instructions
Turn off the power. To avoid electrical shock and/or equipment damage, disconnect electrical power at the main fuse or circuit breaker before installation and maintenance. Be aware that even if the circuit breaker is off, some voltage may remain in ...[C-ZB-DM201-2G] Wiring Instructions
If in any doubt please consult an electrician. Turn off the power. To avoid electrical shock and/or equipment damage, disconnect electrical power at the main fuse or circuit breaker before installation and maintenance. Be aware that even if the ...