[CSF1TZ] Anti-freeze function

[CSF1TZ] Anti-freeze function




Turning on

Press and hold the button of the water timer for 8 seconds until the green light flashes twice to turn on the antifreeze function.

Turning off

Press and hold the button of the water timer for 8 seconds until the red light flashes twice to turn off the antifreeze function.

Notes
The default setting for the antifreeze function is off.
Info

Tips: When the antifreeze function is turned on, and the temperature is lower than 5°C, the water timer will automatically shut down. It will not run again until the temperature is higher than 5°C.



    • Related Articles

    • [CSF1TZ] Smartfoss - Getting Started

      Manual & Documentation Download the Instruction Manual here: Smartfoss Instruction Manual Installation Instructions Battery Installation Factory Reset the Device If you need delete the device from your Smart Life account, or perform a factory reset: ...

    • [CSF1TZ] How do I install Home Assistant ZHA quirks?

      To do this you must have file editor installed on your Home Assistant instance. Editing your configuration.yaml file. On your Home Assistant instance click file editor. Click the folder button ("Browse Filesystem") Select configuration.yaml, and then ...

    • [CSF1TZ] Installing the batteries

      Open the battery slide cover. Remove the battery housing and install 2 x AAA batteries. Re-install the battery housing and slide the cover up back into position.

    • [RD1-Pro] Direct Zigbee Binding

      Introduction The Candeo RD1-Pro with firmware v2 supports direct Zigbee binding, allowing it to control compatible Zigbee lights or Zigbee groups directly. For most Home Assistant users, we strongly recommend using the Candeo binding Blueprints. They ...

    • [CSF1TZ] Losing pressure

      Disassembly instructions If you find you are losing pressure, there is a mesh filter fitted into the top of the device. Please remove this using a small screwdriver or a pair of tweezers.