[C202/C202N] Advanced configuration

[C202/C202N] Advanced configuration


  1. TouchLink to a Zigbee Remote:
    1. Turn on the light, press the knob 3 times with a long press on the third time (3 seconds).
    2. The light will blink 3 times and then stay continuously on to show that the device is in TouchLink commissioning mode. This times out after 3 minutes, after which repeat this step if necessary.
    3. Bring the remote or touch panel within 10cm of the switch.
    4. Set the remote or touch panel into TouchLink commissioning mode, by following the instructions in the corresponding remote or touch panel manual.
    5. Once connected, the light will blink 10 times, and you can control your lights remotely.

    • Related Articles

    • [C205/C-ZB-SM205-2G] Candeo Zigbee Switch Modules - Getting started

      Manual & Documentation Download the Instruction Manual here: C205 Instruction Manual C-ZB-SM205-2G Instruction Manual Wiring Guide Please see our wiring articles: C205 wiring C-ZB-SM205-2G wiring Installation Instructions Our switch modules are ...

    • [C203/C204/C-ZB-DM204] Advanced configuration

      Set up a Touchlink remote Press the reset button 4 times or turn the power off/on 4 times. Bring the remote within 10cm of the module and set the remote into Touchlink commissioning mode. You will need to refer to the instructions that came with the ...

    • [C-ZB-SM205-2G] Advanced configuration

      Set up a Touchlink remote Press the reset button 4 times or turn the power off/on 4 times. Bring the remote within 10cm of the module and set the remote into Touchlink commissioning mode. You will need to refer to the instructions that came with the ...

    • [C202/C202N] Can I use my rotary dimmer as a remote to control the brightess of another device? Or in decoupled mode?

      The simple answer to these questions is no, the dimmer can't be used as a remote, nor can it be decoupled. The rotary dimmer must always have a light circuit connected to it, so there is no way to control another device separately from the light ...

    • [C201] Advanced configuration

      TouchLink to a Zigbee Remote Press the reset button 4 times. The LED will start blinking green indicating that the module is ready for Touchlink mode. Pairing mode will time out after 15 minutes. Bring the remote within 10cm of the module and set the ...