C130-S Wiring

[C130-S] Wiring Instructions



Warning
If you have any concerns about wiring this yourself, please consult a qualified electrician.
  1. Turn off the power
    1. To avoid electrical shock and/or equipment damage, disconnect electrical power at the main fuse or circuit breaker before installation and maintenance.
    2. Be aware that even if the circuit breaker is off, some voltage may remain in the wires — before proceeding with the installation, be sure no voltage is present in the wiring.
    3. Take extra precautions to avoid accidentally turning the device on during installation
  2. This is normally installed just before the first light fitting in the circuit, but can also be installed just after a switch, if you have access to a neutral wire, and switched live wire.
  3. Connect the device according to the diagrams shown below.
General Wiring
Before the first light fitting


After the light switch

Wiring diagram, showing the bypass installed after a light switch, but before a light fitting.
C-ZB-RD1/RD1P Wiring
Installing the bypass at the switch when a neutral wire is available

No Load Wiring for REM Mode
It is possible to the wire the RD1-Pro using Live and Neutral wires, without a wired lamp Load.